Fire and explosion 툴박스 미팅

무엇인가요

Fuel, flammable gases or vapours, dust or hot work igniting and causing fire, burns or explosion.

확인할 관리 조치 (효과가 큰 순서)

1. Substitute non-flammable products where possible, and keep only small quantities of flammable liquids and gases at the work area.
2. Remove or isolate ignition sources, and use intrinsically safe equipment where flammable atmospheres may occur.
3. Store flammable liquids in suitable containers and flammable liquids cabinets, away from heat, oxidisers and exits.
4. Issue hot work permits, clear combustibles from the area and keep a fire watch during and after hot work.
5. Refuel plant and equipment with engines off and cooled, away from hot work and other ignition sources.
6. Keep suitable fire extinguishers close to the work and train workers to use them.

작업 중 어디서 생기나요

fire and explosion 관련 SafetyDocs 템플릿의 작업 단계:

• Discharging fire extinguisher for service requirementsFollow the SDS and never discharge towards a person출처: Fire Extinguisher Installation - Maintenance
• Fire Extinguisher InstallationLocate wall services, control dust, silica and asbestos, and mount extinguishers to AS 2444출처: Fire Extinguisher Installation - Maintenance
• Fire Extinguisher MaintenanceService extinguishers to the manufacturer and AS 1851 and complete the logbook출처: Fire Extinguisher Installation - Maintenance
• Make safe – fire damageMake fire-damaged areas safe출처: Make Safe
• Work area set-upBarricade the work area and control electrical, fire, debris and silica dust hazards출처: Concrete Grinding and Polishing

작업자에게 할 질문

1. 오늘 이 작업에서 어디서 fire and explosion 위험이 생길 수 있나요?
2. 오늘 작업에 다음이 포함되나요: Discharging fire extinguisher for service requirements; Fire Extinguisher Installation; Fire Extinguisher Maintenance?
3. 가장 효과적인 관리 조치는 “Substitute non-flammable products where possible, and keep only small quantities of flammable liquids and gases at the work area”입니다. 여기서 할 수 있나요? 할 수 없다면 왜 그런가요?
4. 이 현장에서 빠졌거나 제대로 작동하지 않는 fire and explosion 관리 조치는 무엇인가요?
5. fire and explosion 때문에 작업을 멈춰야 하는 때는 언제이고, 누구에게 알리나요?
6. 이 작업에서 위험 요소, 아차 사고, 사고는 어떻게 보고하나요?