템플릿 문서는 영어로 작성되어 있습니다.

Cable Ladder Tray-Conduit Installation

SWMS · SWMS-10477

작업 단계 12개
140회 구매됨
버전 3
Electrical - HVAC - Solar
어떤 휴대폰에서든 읽기 가능

This Safe Work Method Statement (SWMS) sets out the safety protocols for installing cable ladders, trays and conduits, so the work is done safely and in line with the relevant regulations.

It takes your crew through 12 job steps, from arriving on site, locating and isolating existing services, and working at height on ladders, trestles and mobile scaffold, to securing fixings, fitting trays, ladders and conduit, completion and emergency response.

It marks the high-risk construction work involved and has the controls for each hazard, a hazard risk matrix and a sign-off for workers. It suits electrical and data cabling contractors, construction companies, facility maintenance teams and site supervisors.

Written by SafetyDocs safety experts, who have been writing safety documents since 2004.

Cable Ladder Tray-Conduit Installation

SWMSVersion 3

Company doing the work: [Company]
Business contact and phone: —
Responsible person (for monitoring SWMS and work): —
Responsible person's phone: —
Responsible person's signature: —
Date signed: —
Principal contractor (PC): [Principal contractor]

PC address: —
PC phone: [PC phone]
Date SWMS provided to PC: —
Job site address: [Site address]
Business contact phone: —
Part of a construction project: —

Site management plan

If the work is part of a construction project, this SWMS must align with the requirements of the Site Management Plan in place for the construction project.

High-risk construction work

This work activity involves the following “High-Risk Construction Work” (HRCW – identified in the Job Task column)

Gas MainsWork on or near pressurised gas distribution mains or piping
Hazardous LinesWork on or near chemical, fuel or refrigerant lines
Energised ElectricalWork on or near energised electrical installations or services
Mobile PlantMobile plant movement
Hazardous AtmosphereWork in an area that may have a contaminated or flammable atmosphere

Planning and preparation

Planning/preparation

Liaise with Principal Contractor to identify on-site safety systems and procedures
Establish supervisory and communication arrangements
Principal contractor to confirm emergency response procedures are in place.

Hold points

Hold points identified and signed off before continuing work. (specify the hold points)

Training/licence

All workers to have a General Construction Induction Card
Relevant workers have relevant certificates of competency, licenses, and training. Specify on the SWMS Sign-off for each worker.
Trained First Aider on site
All workers trained in site-specific emergency and evacuation procedures, SWMS, safe work procedures, and safety data sheets.

Worker duties and responsibilities

Fit condition for work, i.e., no signs of fatigue, alcohol or drugs
Attend all site inductions/briefings
Comply with all site requirements, e.g. PPE, Traffic Management Plans (TMP)
Only carry out work related to the contract
Inspect completed work and report possible safety, environmental and quality matters to the supervisor.

Monitor/review

All people involved in the task must have this SWMS communicated to them before work commences
SWMS to be reviewed and amended if necessary, in consultation with relevant people after any near miss or incident
If additional site hazards identified, review this SWMS and amend control measures to suit
People, including workers, contractors and sub-contractors, affected by the revisions to this SWMS, must be informed ASAP
Give the principal contractor a copy of the revised SWMS
The site supervisor to monitor works against the controls stated in this SWMS
SWMS must be kept on-site and made available for inspection or review
Keep a record of this SWMS until the job is complete or for two years if involved in a notifiable incident
Regardless of any other factor, the person in control of the workplace must review this SWMS at least annually.

Site-specific notes

(add notes specific to this site)

Legislation and codes of practice

None listed.

Personal protective equipment (PPE)

Foot Protection
High Visibility
Head Protection
Eye Protection
Hand Protection

Do not wear rings, watches or jewellery that may become entangled. Long and loose hair must be tied back.

Job steps, hazards and controls

Work activity
Arrival on-site, site assessment & unloading of materials/ equipment
- Hazard
  Personal injury, property damage &/or environmental incident
  Before controls3 High
  Controls
  - The vehicle should be positioned in a safe location, clear of traffic/vehicles/pedestrians during equipment delivery and materials removal (deploy physical barriers, caution signs as necessary)
  - Do not park illegally
  - Identify and obey all safety-related signage (check site entry requirements)
  - Report to Site Supervisor
  - Ensure site-specific induction undertaken
  - Assess mobile phone reception
  - The worksite is exactly as detailed in Terms of Agreement or contract
  - Complete a JSA specifying the control measures of unanticipated hazards.
  After controls2 Moderate
  Responsible
  - Supervisorto check the site and conduct JSA where necessary
- Hazard
  Unsafe delivery location
  Before controls3 High
  Controls
  - Define a specific area for storage, identified with appropriate signage and free of hazards
  - Where possible, provide separate routes for pedestrians and vehicles
  - Design the layout of storage area to minimise risks of collisions between vehicles &/or mobile plant
  - Limit the height of storage stockpiles
  - Keep material and equipment storage areas tidy and well ordered
  - Ensure delivered and stored equipment and material does not present a hazard, e.g. trip hazards or falling objects.
  - Keep adequate access for installers and their equipment.
  After controls2 Moderate
  Responsible
  - Supervisorto check the site and conduct JSA where necessary

IR before controls · RR after controls1 LLow2 MModerate3 HHigh4 AAcute

Overall risk after controls2 MModeratethe highest rating after controls

Work activity
Work area set-up
Set up a secure work area.
Work activity
Locate & isolate existing services
Identify and isolate existing services.
Work activity
Environment
Control the environmental hazards of the work.
Work activity
House keeping
Keep the work area clean and safe.
Work activity
Manual tasks
Lift and handle materials safely.
Work activity
Working with powered & non-powered tools
Use powered and non-powered tools safely.
Work activity
Hazardous substance /chemical use
Store and handle chemicals properly.
Work activity
Working at height on ladders, trestles & mobile scaffold
Work safely at height on ladders, trestles and mobile scaffold.
Work activity
Securing fixings, supports, fitting trays, ladders & conduit
Fix supports and install trays, ladders and conduit securely.
Work activity
On completion
Clean up, remove isolation and leave the site safely.
Work activity
Emergency response
Respond to an injury or incident.

Permits

Plant and equipment

Hazardous substances

Supervisory arrangements

SWMS Sign-off

This SWMS developed in consultation and cooperation with workers and relevant organisation representatives. I have read the above SWMS, and I understand its contents. I confirm that I have the skills and training, including relevant certification, to conduct the task as described. I agree to comply with safety requirements within this SWMS, including risk control measures, safe work instructions, and PPE described.

Worker’s name	Job role / positione.g. supervisor, worker, trainee	Licences, competencies & qualificationsType / descriptionClassNumber	Date	Signature
-	-	-	-	-
-	-	-	-	-
-	-	-	-	-
		General construction induction (White Card)
		General construction induction (White Card)
		General construction induction (White Card)
		General construction induction (White Card)
		General construction induction (White Card)
		General construction induction (White Card)
		General construction induction (White Card)
		General construction induction (White Card)
		General construction induction (White Card)

Hierarchy of controls

Risk matrix

Step 1: Determine likelihood

Likelihood	Criteria	Description

Step 2: Determine consequence

Level of Effect	Example of each level

Step 3: Determine the risk score

Likelihood ↑	InsignificantNo effect, or so minor that the effect is acceptable	MinorMinor first aid treatment, minimal business disruption, minimal environmental effect	ModerateSerious injuries, medium business interruption, medium environmental impact	MajorExtensive injuries or fatality, significant business interruption, environmental harm, prosecution	CatastrophicMultiple permanent disabilities or fatalities, business failure, substantial environmental harm, prosecution or imprisonment
	Consequence →
Almost certainExpected in most circumstances	2 Moderate	2 Moderate	3 High	4 Acute	4 Acute
LikelyWill probably occur in most circumstances	2 Moderate	2 Moderate	3 High	4 Acute	4 Acute
PossibleCould possibly occur at some time	1 Low	2 Moderate	2 Moderate	3 High	4 Acute
UnlikelyUnlikely but possible	1 Low	1 Low	2 Moderate	3 High	4 Acute
RareHighly unlikely to occur	1 Low	1 Low	2 Moderate	2 Moderate	3 High

1 LowRecord and monitor. Proceed with work, and review the risks regularly.
2 ModerateMaintain control measures. Be cautious when working, and monitor and review regularly.
3 HighReview before commencing work. Introduce new controls or maintain high-level controls to lower the risk level, and monitor the controls frequently.
4 AcuteDo not proceed until the risk level is reduced. Immediately introduce high-level controls, and re-assess before proceeding.

Step 4: Record risk

작업 단계 11개 더: Work area set-up부터 Emergency response까지

단계마다 위험 요소, 위험도 평가, 관리 조치가 있고, 작업자 서명란도 포함됩니다.

에디터 무료로 써 보기 이 템플릿 받기

브라우저에서 보이는 모습

이 템플릿 받기

무료로 가입한 뒤 받는 방법을 선택하세요. 회사 정보는 자동으로 채워집니다.

유료 요금제에 포함
요금제의 템플릿 크레딧을 사용하세요. 이 템플릿은 1입니다.
요금제와 가격 비교
한 번 구매하기
$89.95 한 번 결제로 계속 소유합니다. 무료 요금제에서도 사용할 수 있습니다.

에디터 무료로 써 보기 무료 가입

가입에 카드가 필요 없습니다. 얼리 액세스 회원은 모든 요금제에서 30% 할인을 받습니다.

다루는 내용

작업 단계 12개

Arrival on-site, site assessment & unloading of materials/ equipmentCheck the site and unload materials and equipment safely.
Work area set-upSet up a secure work area.
Locate & isolate existing servicesIdentify and isolate existing services.
EnvironmentControl the environmental hazards of the work.
House keepingKeep the work area clean and safe.
Manual tasksLift and handle materials safely.
Working with powered & non-powered toolsUse powered and non-powered tools safely.
Hazardous substance /chemical useStore and handle chemicals properly.
Working at height on ladders, trestles & mobile scaffoldWork safely at height on ladders, trestles and mobile scaffold.
Securing fixings, supports, fitting trays, ladders & conduitFix supports and install trays, ladders and conduit securely.
On completionClean up, remove isolation and leave the site safely.
Emergency responseRespond to an injury or incident.